2 Number Plated Mounted Sensors - Plus Reversing Camera


£79.99 Inc VAT

£66.66 ex. tax
? Tax based on United Kingdom.

2 Number Plated Mounted Sensors - Plus Reversing Camera - Description

Dolphin PPS200C Number Plate Parking Sensor Kit
The PPS200C parking sensor system is designed for an easy installation where you cannot or do not want to drill a bumper to fit parking sensors and or a reversing camera. The two sensors are neatly mounted into each side of the number plate frame. The camera then sits in the middle facing directly outwards. The camera produces a colour image of the rear of your car showing reversing guidelines and an overlay of digital countdown in distance for each of the left and right sensors. Please note this kit DOES NOT includes a monitor. For a kit including a monitor see the PPS200CM43.

Kit Contents

  • 2 x Sensors
  • 1 x Colour Camera
  • 1 x Buzzer
  • 1 x EU Number Plate Frame
  • 1 x Power Lead
  • Instruction Manual
2 sensors with camera in numberplate system

How it works
The number plate frame replaces the frame that comes on many European cars as standard or it attaches to the car using the current screw holes securing the number plate and your number plate then clips into the frame. You may then need to make one small hole behind the number plate to feed a single cable through to inside the car or depending on your vehicle this could be routed upwards under a boot handle and into the car. As with our standard parking sensor systems the PPS200C then simply connects to the reversing light bulb for power and then is comes on automatically when you select reverse gear. 

There is no separate control box on this kit, all the electronics are built into the number plate frame leaving a single cable routing though into the vehicle that has connector for the supplied buzzer, power and the camera output. The camera has some little locking screws allowing you to adjust the angle of the camera up and down depending on the height you have mounted.

Buzzer The PP200C also comes with a buzzer which you also mount in the boot which gives you audio beeps starting at 1.5m which will increase in frequency as you get closer to an object giving you a constant tone to stop at 30cm.
200 - 160cm
Safe Mode
150 - 100cm
Safe Mode
90 - 50cm
Alarm Mode
40 - 30cm
Danger Mode
30 - 0cm

As mentioned above this model does not come with a monitor so you would need to supply your own or choose one from our range. We do a combined kit with our recommended monitor, the 4.3 inch mirror mounted monitor, this is the PPS200CM43.
Sample Output on to a mirror monitor

Sample output - Mirror monitor not included (if you want it you need the PPS200CM43)

Some Useful Measurement Information

(measurements are approximate and not guaranteed)

Component Length x Width x Depth
Size of Buzzer

59mm x 40mm x 17mm

Length of Cabling for Buzzer
Size of Processor
96mm x 68mm x 26mm
Size of Number Plate Holder
532 x 134 x 28.2mm
Sensor Detection Angle
110 deg
Camera Filming angle
120 deg

No routine maintenance or adjustment is required. Dirt, frost or snow accumulated on the sensors may cause the system to activate incorrectly. The sensors can be washed carefully with warm soapy water

Customer Reviews

No Reviews Posted Yet - be the first!(write review)

Related Products

Recently Viewed Products

Pay with PaypalPay by other
Paypal Card payments via Sage Pay Phone Us